ACRIPOL METALIZADO

Stir the product until perfectly blended.
Apply to clean, dry substrates, remove any waste matter using degreasers or detergents and clean water.
The desired metallic finish can be achieved with one or two coats.
Do not apply the product at high temperatures or on surfaces exposed to strong sunlight.
Maintain good ventilation conditions while drying.
Do not apply with relative moisture above 80%.
Given the broad spectrum of bases, for direct applications on problematic surfaces, it is recommended that you first carry out adhesion tests. If false adhesion is detected, prime as indicated in the attached table.
As a preventive measure, prime using the products indicated in the table attached. On tiles and ceramic surfaces, carry out adhesion tests.

Soporte Nuevo:
-Enamelled iron and derivatives:
1. On paintwork which is in good condition, sand down to open the pore, checking that the adhesion is perfect.
2. On paintwork in bad condition, remove paint by mechanical or chemical means and proceed as with new bases.
Varnished or painted wood:
1. If the wood has been varnished with Montoxyl colour (code1300): Remove foreign products, remove any loose or peeling varnish, lightly sand, remove dust from sanding and proceed as with new woods.
2. If they have been varnished, strip down using Quitamont or by mechanical means and proceed as with new wood.
Plaster work (plaster, cement or derivatives):
1. On paintwork which is in good condition, sand down to open the pore, checking that ther adhesion is perfect.
2. On paintwork which is in poor condition or vulnerable to attack by the product, remove by mechanical or chemical means and proceed as with new plaster/cement work. Restauracion y Mantenimineto:
-Enamelled iron and derivatives:
1. On paintwork which is in good condition, sand down to open the pore, checking that the adhesion is perfect.
2. On paintwork in bad condition, remove paint by mechanical or chemical means and proceed as with new bases.
Varnished or painted wood:
1. If the wood has been varnished with Montoxyl colour (code1300): Remove foreign products, remove any loose or peeling varnish, lightly sand, remove dust from sanding and proceed as with new woods.
2. If they have been varnished, strip down using Quitamont or by mechanical means and proceed as with new wood.
Plaster work (plaster, cement or derivatives):
1. On paintwork which is in good condition, sand down to open the pore, checking that ther adhesion is perfect.
2. On paintwork which is in poor condition or vulnerable to attack by the product, remove by mechanical or chemical means and proceed as with new plaster/cement work.