CREA ESMALTE DIRECTO OXIDO

• Stir the product until perfectly homogeneous. - Apply on clean and dry substrates, removing dirt with degreasers or detergents and clean water. - Apply following the rules marked in the attached application chart. - Do not apply the product at high temperatures or on surfaces exposed to strong sunlight. - Do not apply with relative humidity above 80%. - New metals: clean, degrease, and remove any poorly adhered residues. For light metals and galvanized, check adherence beforehand.

• Rusty metals and painted metals: clean and previously remove poorly adhered residues.

• Apply between 4 and 5 coats minimum, one vertically and the other horizontally to compensate for irregularities in the support or possible defects derived from a faulty application, ensuring a minimum dry layer thickness of 130 microns to optimize results, at intervals of at least two hours between coats.

• Respect the minimum and maximum intervals between coats. - Respect the recommended maximum and minimum film thicknesses according to performance.

• Do not apply on supports wet from low night temperatures (morning dew) or overheated as it can affect the short and long-term quality of the product. - Maximum storage time: 12 months from its manufacturing date in its perfectly closed original packaging, covered and at temperatures between 5º and 35ºC. - Consult and comply with the MANDATORY STANDARDS MARKED BY CURRENT CEE LEGISLATION for MARKETING. - Comply with the standards indicated on the packaging according to CURRENT CEE LEGISLATION. - Given the wide variety of plastic supports and alloys (galvanized, leaded, zinc-coated.

.

.

), it is advisable to carry out a preliminary test before painting to confirm the correct properties of the product on the support to be painted.

New support:

New metallic supports: - Remove rust and laminating scales by mechanical or manual brushing. - Remove grease and degrease. - Remove poorly adhered old paint.

• Ensure that the support is completely dry. Galvanized and light metals: - Degrease perfectly and check adherence. Restoration and Maintenance:

• Remove rust and foreign substances using usual procedures. - Apply on clean and dry substrates, removing dirt with degreasers or detergents and clean water. - Since a lack of adherence between previous layers is possible, it is recommended to remove old layers by stripping, blasting, or other means.