MICROCEMENT FLOORS

- Environmental conditions: - It is recommended, especially indoors, that there be air renewal. - Ambient temperature: 5-35 ºC - RH ≤ 75%. - This range must be maintained during the first 72 hours. - Substrate temperature ≥ 8ºC and 3ºC above the dew point. Essential to avoid condensation. - Variations in ambient temperature during the application process also alter the setting and drying times of the material. Below 20ºC, the drying time increases.
- Preparation of the mixture: - In the empty bucket that is included in the pack, pour the MICROCEMENT RESIN with color and previously shaken. The proportion is 13 Kg Part A (Powder) + 5 Kg Part B (Resin with color). - Sprinkle little by little and beat by mechanical stirring until obtaining a homogeneous paste free of lumps.
-Application conditions: - Apply with a steel trowel with rounded edges, in thin layers, 2 to 3 layers depending on the application, leaving 2 to 3 hours between coats, until the desired decorative effect is achieved. - On tiles use MICROCEMENT BASE and fiberglass mesh. - Consumption calculated on MICROCEMENT BASE: - Per coat: 0.
8 Kg / m2 (approx 0.
4 mm thick). (13 A + 5 B for 10 m2) - Total: 1.
6 - 2.
4 Kg / m2 (0.
8 - 1.
2 mm thick). (13 A + 5 B for 4 - 8 m2) - Maximum thickness of the entire BASE + WALLS system (1 to 3 mm)- End use: - After 24 hours, sand the entire surface well, with a fine sandpaper with a grain greater than 180. - We perfectly clean the dust generated, vacuuming. - Continue with the Microcement SEALER. - Optimal mechanical properties are reached after 28 days. - The MICROCEMENT Ó deco system is not recommended for liquid containment supports, such as swimming pools, tanks or bathtubs.

Soporte Nuevo:
Over Microcement Base:
- Sand with 120/180 clean and remove the dust well, preferably by vacuuming. Restauracion y Mantenimineto:
- Sand with 220 or higher, removing dust well, preferably by vacuuming.
- Proceed as in NEW SUPPORTS.