MICROCEMENT PROTECTOR DECO MAT

• Environmental conditions:

  • It is advisable, especially indoors, to have air renewal.
  • Room temperature: 5-35 ºC.
  • Relative humidity (RH): ≤ 75%.
  • Substrate temperature: ≥ 7ºC and 3ºC above the dew point.

• Mixing preparation:

  • By manual or slow mechanical agitation, homogenize the MICROCEMENT PROTECTOR DECO.
  • Add the amount of water according to the application method and the surface to be varnished.
  • Control the speed to prevent the mixture from acquiring excess air.

• Dilution:

  • For walls and roller application, a maximum of 10% water. If spraying, an additional 5% can be added.
  • For floors and roller application, it is possible to increase the dilution by an additional 5%. If spraying, an additional 5% can be added.
  • Distilled water in all cases.

• Application conditions:

  • Wait at least 4 hours, and no more than 24 hours, from the application of the last coat of MICROCEMENT SEALER before starting to varnish with MICROCEMENT PROTECTOR DECO.
  • The recommended thickness per layer is between 40-50 microns dry.
  • In all applications, make sure not to leave more than 110 g/m2 of product.
  • 2 coats. For greater resistance, a third coat can be applied.

• Final use:

  • The varnished surface reaches its maximum physical resistance after 21 days (at a temperature of 20 ºC).
  • The Microcement Ó Deco System is not recommended on supports containing liquids, such as pools, tanks, or bathtubs.
  • The Microcement Ó Deco System finished with MICROCEMENT PROTECTOR DECO (1K) is suitable for less demanding uses on vertical surfaces such as walls, furniture, etc.
  • For use in humid environments and/or on demanding horizontal surfaces, use MICROCEMENT PROTECTOR (2K).

New Support:

MICROCEMENT Ó Deco:

1. On dry MICROCEMENT SEALER.
2. Verify that the surface appearance is as desired.
3. Ensure that the support surface is clean, dry, and free of any contaminants.
4. Apply two coats of MICROCEMENT PROTECTOR DECO, respecting the drying times.

Restoration and Maintenance:

MICROCEMENT Ó Deco with aged coatings:

1. Remove all old coating by sanding.
2. Sand the MICROCEMENT Ó Deco surface with medium-grit sandpaper (to provide anchorage).
3. Remove dust generated effectively.
4. Apply a new coat of MICROCEMENT Ó Deco.
5. Act as a new support.