LUXATIN ECOLOGICO SATINADO

Painted plaster, cement and their derivatives:

1. Remove any foreign substances that have not correctly adhered to the surface or that are in poor condition. Sand the surface or use other mechanical means to open the pores if necessary. Treat as in new construction.

Varnished or painted wood:

1. If it has been varnished or painted, remove foreign products, poorly adhered areas or areas in poor condition, sand lightly, remove sanding dust and proceed as for new wood.

Iron and enamelled derivatives:

1. On paints in good condition, sand to open the pore, checking that the adherence is perfect.

2. On paint in bad condition, remove it by mechanical or chemical means and proceed as if it were a new surface.

Galvanised and light metals:

1. On paints in good condition, sand to open the pore, checking that the adherence is perfect.

2. On paint in bad condition, remove it by mechanical or chemical means and proceed as if it were a new surface.

PVC and plastics:

1. On paints in good condition, sand to open the pore, checking that the adherence is perfect.

2. On paint in bad condition, remove it by mechanical or chemical means and proceed as if it were a new surface.

Ceramics, tiles and glass:

1. On paints in good condition, sand to open the pore, checking that the adherence is perfect.

2. On paints in bad condition, remove it by mechanical or chemical means and proceed as if it were a new surface.

Gypsum, cement and its derivatives:

1. Wait until fully cured.

2. Clean the surface of possible efflorescence and neutralise alkaline surfaces. Putty any defects in the surface with suitable filler.

3. Treat mouldy surfaces with Montolimp.

4. Then apply Fixing Emulsion or Fijamont before application.

New wood:

1. Apply on wood with a moisture content lower than 20%. Sound, well degreased, dust-free and dry wood.

2. If the wood shows signs of ageing, it must be previously sanded, primed and the dust removed by brushing or any other mechanical means.

3. Before application, it shall be primed with Selladora Sellalux.

Iron and its derivatives:

1. Apply on well degreased, dust-free and dry surfaces. If they show signs of rust, the dust must be removed by brushing or other mechanical means. Oxifín is also suitable.

2. Subsequently, before application, treat with Acqua Anticorrosive Primer

Galvanised and light metals:

1.- Degrease thoroughly and check adhesion.

2.- If necessary, it is recommended to prime with Montoprimer Total Acqua.

PVC and plastics:

1.- Degrease thoroughly and check adhesion.

2.- If necessary, it is recommended to prime with Montoprimer Total Acqua.

Ceramics, tiles and glass:

1.- Degrease thoroughly and check adhesion.

2.- If necessary, it is recommended to prime with Montoprimer Total Acqua.