White two-component anticorrosive primer, based on solvent-based acrylics crosslinked with aliphatic isocyanates, for application on ferrous metal surfaces. An ideal base for repainting with ACRIPOL + ACRIPOL CATALYST.

8 - 12 m²/L
Drying time
15 min
4L 0.75L



How to apply?

Airless spray gun
Air mix spray gun
Low-pressure turbine



  • Stir both products until they are perfectly homogeneous.
  • Mix in the prescribed proportions and let the mixture sit for about 5 minutes.
  • It is recommended to achieve total coating thicknesses between 25 and 100 microns, depending on the desired protective effect.
  • Apply to clean and dry substrates, removing dirt with degreasers or detergents and clean water.
  • Apply following the instructions provided in the attached application chart.
  • Do not apply the product at high temperatures or on surfaces exposed to strong sunlight.
  • Maintain good ventilation conditions during the drying time.
  • Do not apply at relative humidities higher than 80% and apply at temperatures above 5º C.
  • If you exceed the recommended maximum interval for repainting, sand to ensure good adhesion between coats and verify that the adhesion is correct. Otherwise, remove the coating.

New Substrate:

  • New metal substrates:

  • The substrate must be free of foreign substances, rust, and/or residues.

  • Apply to well degreased, dust-free, and dry substrates.

  • For maximum protection, especially on iron and its derivatives, a pretreatment to remove mill scale and rust spots is required. This consists of abrasive blasting of the metal to at least the Swedish Standard (SIS 055900) Sa2 level. If abrasive blasting is not viable due to cost considerations, the metal should be treated with a hard metal scraper and wire brush to achieve at least the Swedish Standard (SIS 055900) St3 level.

Restoration and Maintenance:

  • Enameled iron and its derivatives:

  • Follow the guidelines provided for new substrates regarding the removal of foreign substances, degreasing, cleaning, and the presence of rust.

  • Since there may be an adhesion defect between previous coats, typically unknown to the applicator, and the primer, it is recommended to remove them using stripping, abrasive blasting, or other methods.

  • Subsequently, treat with Impriepox M-10 + Catalyst Impriepox M-10.


I´m interested in this product
I´m interested in this product

Confirm the product and your contact information to be able to inform you and advise you in a personalized way.

Readily available stock

Gestión automatizada de las ubicaciones y las existencias de los productos.

Perfect orders

Los pedidos son preparados mediante radiofrecuencia reduciendo los errores en su preparación a 0.

Warehouse management

Ubicación automática de los productos en el almacén mediantes transelevador.

Fast loading

8 loading docks for 24-ton trucks.

Our own transport

Flota propia de camiones de reparto preparados para transporte ADR.

We are always close by

Cadena de tiendas propia y suministro a puntos de venta en toda España.