SMART ANTI RADIACIONES

- How to use. For optimum shielding the paint should be applied undiluted.
- Shake the product until it is fully blended.
- For "difficult" surfaces, dilute the product according to the porosity and condition of the substrate in the first coat.
- Use the same paint to finish, until the appropriate thickness is reached according to the application.
- Do not apply the product at temperatures below 5º C or above 35º C, or if there is an imminent risk of rain.
- Do not apply in full sun or on days with excessive humidity.
- A correct prescription should be sought from a qualified professional when implementing the paint in systems where the shielding functions alongside other processes.

Soporte Nuevo:
-Cement mortar:
- Wait until totally set, at least 30 days.
- Use an abrasive jet to remove any potential efflorescence from the base and neutralise alkaline surfaces.
- Sand highly polished surfaces to roughen them slightly.
-Use a suitable fixative to fix crumbly bases (See family 6).
- Remove any other products and/or residue from the base.
- Use plaster to fill any defects in the base (to make a suitable selection, see the PREPARING BASES family for lines of powder plaster and prepared fillers).
- Plaster:
- Wait until it is fully dry maximum 20% humidity.
- Remove any other products and/or residue from the base.
- Remove any efflorescence.
- Use a suitable sealant primer to regulate surface absorption.
- Sand highly polished surfaces to roughen them slightly.
-Use a suitable fixative to fix crumbly or floury bases (See family 6).
- Use plaster to fill any defects in the base (to make a suitable selection, see the PREPARING BASES family for lines of powder plaster and prepared fillers). -Treat mouldy bases with Montolimp. Restauracion y Mantenimineto:
1. Fully remove any old paint that is loose or in poor condition.
2. Glossy surfaces should be sanded lightly to improve adhesion.
3. For painted bases, check the solidity, adhesion and nature of the paint to avoid possible incompatibilities and clear off any dust and dirt before repainting.
4. Use plaster to fill any defects in the base (to make a suitable selection, see the PREPARING BASES family for lines of powder plaster and prepared fillers). 5.
Treat mouldy bases with Montolimp.