MONTOSPORT PISCINAS POSEIDON STD CLO.

Apply on well-dried bases.
You must check the adhesion of the paint to old paint between coats, as it is common to repaint swimming pools regularly, meaning that the adhesion between coats can be greater than the adhesion of the old paint to the base, causing chipping of layers of paint that are weakly adhered.
Should you treat the surface with hydrochloric acid to open the pore, clean with plenty of water and leave to dry.
Dilute the product according to the porosity and state of the base.
This product is resistant to chlorine and chlorine derivatives if concentration is within the limits indicated in RD 742/2013, 27th of September.
For any other treatment (flocculants, algaecides .
.
.
), check with the supplier the possibility to be used in painted pools.

Soporte Nuevo:
Cement mortar:
- Wait until completely set (minimum 30 days).
-Use an abrasive jet to remove any potential efflorescence from the base and neutralise alkaline surfaces.
-Sand down highly polished surfaces to open up the mortar.
-Remove any foreign products and/or residues from the base.
-Use outdoor plaster to fill any defects in the base (in PREPARING BASES family, see lines corresponding to powder plaster and prepared fillers to select a suitable solution).
-Treat mouldy bases with Montolimp. Restauracion y Mantenimineto:
Fully remove any old paint that is loose or in bad condition.
Dull down glossy surfaces to ensure good adhesion.
On painted bases, check the solidity and anchorage of the paint and the paint type in order to avoid potential incompatibilities. Remove dust and dirt before repainting. It is recommended that you don not apply it over water-based swimming pool paint-Use outdoor plaster to fill any defects in the base (in PREPARING BASES family, see lines corresponding to powder plaster and prepared fillers to select a suitable solution).
Walls with mould should first be treated with Montolimp.