MONTOSPORT PISCINAS POSEIDON PLUS AL CL.

Apply on well-dried bases.
You must check the adhesion of the paint to old paint between coats, as it is common to repaint swimming pools regularly, meaning that the adhesion between coats can be greater than the adhesion of the old paint to the base, causing chipping of layers of paint that are weakly adhered.
If you treat the surface with hydrochloric acid to open the pore, clean with plenty of water and leave to dry.
Dilute the product according to the porosity and state of the base.

Soporte Nuevo:
Cement mortar:
-Wait until completely set (minimum 30 days).
- Use an abrasive jet to remove any potential efflorescence from the base and neutralise alkaline surfaces.
-Sand down highly polished surfaces to open up the pores.
-Remove any foreign products and/or residues from the base.
-Use outdoor plaster (Plasmont Exteriores) to fill any defects in the base (in PREPARING BASES family, see lines corresponding to powder plasters and prepared fillers to select an appropriate product).
-Treat mouldy bases with Montolimp.
-Apply a very diluted (approx. 30%) first coat.
-Apply one or two equally diluted coats or-Apply a single 5-15% diluted second coat. Restauracion y Mantenimineto:
1. Completely remove any old paint that is flaking or in poor condition.
2. Dull down glossy surfaces to ensure good adhesion.
3. For painted bases, check the solidity, adhesion and nature of the paint to avoid possible incompatibilities and clear off any dust and dirt before repainting. It is recommended that you do not apply it over water-based swimming pool paint.
4. -Use outdoor plaster (Plasmont Exteriores) to fill any defects in the base (in PREPARING BASES family, see lines corresponding to powder plaster and prepared fillers to select a suitable solution).
5. Walls with mould should first be treated with Montolimp.
6. Apply a very diluted (approx. 30%) first coat.
7. Apply one or two equally diluted coats or8. -Apply a single 5-15% diluted second coat.