MONTOSPORT PISCINAS AL AGUA

- Stir the product until perfectly homogenised.
- Dilute the product according to the porosity and state of the base on the first coat.
- Finish with one or two slightly diluted coats, until the base has full coverage.
-Adhesion should be checked between coats of paint on old paint given that it is usual to repaint swimming pools regularly, therefore adhesion between coats may be greater than the adhesion of the old paints on the case and this could cause peeling of the old coats of paint.
This product is resistant to chlorine and chlorine derivatives if concentration is within the limits indicated in RD 742/2013, 27th of September.
For any other treatment (flocculants, algaecides .
.
.
), check with the supplier the possibility to be used in painted pools.

Soporte Nuevo:
Cement mortars:
1. Wait until fully hardened (min. 30 days).
2. Clean off possible efflorescence with an abrasive jet.
3. Neutralise alkaline surfaces.
4. For polished surfaces: sand down to open the grain.
5. Clean any unusual products from the base.
6. Fix crumbling bases using fixative emulsion or Fijamont.
7. Fill in any defects/flaws in the base. Plaster:
1.
Wait until the plaster is dry (maximum 20% humidity).
2.
Clean any unusual products from the base.
3.
Clean off possible efflorescence with an abrasive jet.
4.
Control the absorbency of the base using a sealer, fixative or a diluted coat of the same product.
5.
For polished surfaces: sand down to open the grain.
6.
Fix crumbling bases using fixative emulsion or Fijamont.
7.
Fill in any defects/flaws in the base (see family 6) Restauracion y Mantenimineto:
1 -Completely remove any old or loose paint.
2 -Dull down glossy surfaces to ensure good adhesion.
3 -On painted bases, check the solidity and anchorage of the paint and the type of paint in order to avoid potential incompatibilities. Remove dust and dirt before repainting.
4 -Fill in any defects in the base using plaster.
5 -Walls with mould, treat first with fungicide (Montolimp).