MAGNUM

New Support:

Cement and concrete mortars:

1. Wait until fully set (min. 30 days).

2. Clean any efflorescence with a jet washer.

3. Neutralize alkaline surfaces.

4. Sand polished surfaces to create a rougher surface.

5. Clean the surface to remove foreign products.

6. Set crumbly substrates with Fixer Emulsion or Fijamont.

7. Fill in defects in the substrate (see family 6)Plaster, plaster-covered brick:

1. Wait until it is completely dry (max. 20% humidity).

2. Clean the surface to remove foreign products.

3. Clean any efflorescence with a jet washer.

4. Regulate surface absorption with sealer, fixer, or a diluted coat of the same product5. Sand polished surfaces to create a rougher surface6. Set crumbly substrates with Fixer Emulsion or Fijamont.

7. Fill in defects in the substrate (see family 6)Plasterboard partition walls:

1. Carry out a general sanding of the joints and putty fixing areas.

2. Then, clean them to ensure the substrate is free of dust, grease and other contaminants.

3. For application on coloured boards that tend to generate stains, apply Monoplac Stain-Resistant Sealer. 

Restoration and maintenance:

1. Completely remove old paint that is in poor condition or that is poorly-adhered.

2. Glossy surfaces should be thinned out to ensure good adhesion.

3. On painted surfaces, check that the paint is solid and well-adhered. Its condition must be assessed, in order to avoid possible incompatibilities. Dust and dirt must also be eliminated before repainting.

4. Apply filler (Plasmont) to any defects on the surface.

5. Pre-treat mouldy walls using Montolimp.