TIXOWAY ANTIMANCHAS

- Shake product until perfectly homogenized.
- Follow application guidelines as shown on table below.
- Optimal results can be obtained with one single coat of Tixoway Antimanchas, however, extreme cases may need a second coat.
- Do not apply product at high temperatures or on overheated surfaces exposed to sunshire.
- Do not apply when moisture content is over 80%.
- Keep room well ventilated while product is drying.
- No need to finish with plastic paints. In case of carrying out this operation, never before 7 days.

Soporte Nuevo:
Cement morter:
- Wait till complete drying of product (30 days minimum).
- Surface should be totally dry (maximum 20% moisture content).
- Remove off any efflorescences and neutralize alkaline surfaces.
- Extremely polished surfaces should be sanpapered to open pores.
- Remove off any foreing products or remains.
- Only apply product on dry and free of dust surfaces- Cover surface imperfections with suitable plaster (See Family 6 to help you choose the most suitable product to prepare surfaces).
- For extreme cases with anchoring problems, apply Fijalite.
New wood:
- Surface should be free of any foreign products or remains.
- Apply on wood with less than 20% moisture content.
- Apply on wood in good condition, dry and free of grease and dust.
- Sandpaper and eliminate any remains in joints and mechanical faults.
- Old wood should be previously sandpapered and primed. Remove any dust by brushing off or using any other mechanical system.
- We recommend applying Montoxyl Fondo (ref. 1301) as a preventive fungicidal treatment.
Iron or steel:
- Remove surface off any rust, grease or dirt and prime with ANTIOXIDANTE BLANCA (ref. 1800) or MINIO DE PLOMO MARINO (ref.
1810). Restauracion y Mantenimineto:
- Old paint in bad condition and with poor adhesion should be removed.
- Product should be applied directly on oil, grease, nicotine or smoke stains.
- Extreme cases should be previously cleaned with hot water and detergents.
- Leave to dry and proceed to paint.