MONTOSINTETIC METALIZADO GRIS PLATA

Stir the product until evenly blended.
Apply to clean and dry substrates, eliminating dirt or grease using degreasers or detergents and clean water.
The desired metallic finish can be achieved with one or two coatsDo not apply the product in extreme temperatures, or on surfaces exposed to strong sunlight.
Ensure good ventilation while product is drying.
Do not apply with relative humidity above 80%. Prime with the products indicated in the attached table.

Soporte Nuevo:
Iron and its derivatives:
-To protect the surface, prior to decorating, treat with suitable primers (family 6) following the specifications given on the product information sheet.
-The surface to be painted must be free of other products and/or residues, grease and dust free, and dry. Any signs of rust should be removed by brushing or any other mechanical means. Oxifín may also be used (see product technical information sheet).
-New wood:
-The base must be free of foreign materials and/or residues.
-Apply to wood with a moisture content of less than 20%.
-Apply to wood that is healthy, dry and free of grease and dust.
-Sand down to remove any traces of glue in joints or milling defects.
-If the wood shows signs of ageing, it should first be sanded down, primed and any dust removed by brushing or any other mechanical means.
-In this instance the most suitable primer is Selladora Sellalux.
-Work elements (plaster, cement and derivatives):
-Treat these surfaces in the usual way, removing saltpetre, excess moisture and efflorescence.
-Remove foreign products and/or residue.
-Once dry, prime using Selladora Sellalux. Restauracion y Mantenimineto:
-Iron and its derivatives, enamelled:
-On paintwork that is in good condition, sand down to open the pores, checking that the adhesion of the paint is perfect.
-Remove paint in poor condition using mechanical or chemical means and proceed as on a new surface.
-Varnished or painted wood:
-If varnished with Montoxyl colour (code 1300): remove foreign products, remove any loose or peeling varnish, lightly sand, remove dust from sanding and proceed as on new wood.
-If varnished, remove by stripping with Quitamont Universal (code 3510) or by mechanical means and proceed as on new wood.
-If enamelled with synthetic enamel (Montosintétic (code 2020, code 2024), Marisma (code 2010, code 2014), Luxatín (code 2028) or similar, open pores by sanding, eliminate the resulting dust and proceed as on new wood.