MARTELE

-Product should be homogenized properly.
-Spray first coat slightly. Apply than a second or even a third coat.
-Do not apply product at high temperatures or overheated surfaces exposed to sunshine.
-Keep room well ventilated while product is drying.
-Do not apply when moisture content is over 80%.
-Minimum time given between coats must be observed to avoid brittle surfaces.
-Maximum time given between coats must be observed at all times to avoid adherence problems

Soporte Nuevo:
New wood:
1 -Surface should be free of any foreign products or remains.
2 -Apply on wood with less than 20% moisture content.
3 -Apply on wood in good condition, dry and free of grease and dust.
4 -Sandpaper and eliminate any remains in joints and mechanical faults.
5 -Old wood should be previously sandpapered and primed. Remove any dust by brushing it off or using any other mechanical system.
6 -We recommend priming with Selladora Sellalux.
Iron and by-products:
1 -For surface protection prior to decoration, apply a suitable primer (See familily 6) following data sheet guidelines.
2 -Prior to decoration, surface should be free of any foreign products, grease, dust and completely dry. Should it show any rust, apply Oxifin or remove it by brushing off or any other mechanical system.
Construction (plaster, cement and derivatives):
1. To deal by habitual way these supports, being eliminated salpeters, excesses of humidity and efflorescences.
2. To eliminate strange products and/or remainders.
3. Once dry to print with Sellalux Primer. Restauracion y Mantenimineto:
Painted or varnished surfaces:
1 -If they have been varnished with Montoxyl Color, remove off foreign remains, or areas in bad condition, sandpaper slightly, brush any resulting dust and proceed as per new wood.
2 -If the have been varnished, apply a stripping product such as Quitamont Universal or use a mechanical system and proceed as per new wood. 3 -If they have been painted with synthetic enamels (such as Montosintetic, Marisma, Luxatin or similar, sandpaper slightly to open pore, brush any resulting dust and proceed as per new wood.
Iron and its enamelled by-products:
1 -For supports paints in good condition, sandpaper slightly to open pore and test adherence level.
2 -supports paints in bad condition should be removed by mechanical or chemical systems and proceed as per new surfaces.