FERRORITE FORJA

Apply over dry and clean surfaces, using clean water and detergent / oil cleaning detergent.
- Prepare surfaces as explained in “Surface preparing”- Stir the product till it is totally homogeneous.
-Apply following dilutions specified in application systems- Do not apply the product under extreme temperatures, neither over surfaces exposed to strong insulation.
- Keep good ventilation conditions while drying.
- Do not apply with relative humidity higher than 80%.
Over old paint when its composition is unknown or do we doubt over its adherence it is always convenient to make previous adherence testing.

Soporte Nuevo:
Iron and steel:
- New and rust covered: - To paint the support it must be free of strange residues, oil or fat, without any dry calamine. - If it presents any sign of rust, this must be eliminated, using sand paper and eliminating any particle that may be loose (especially loose particles of rust and calamine). Next apply Ferrorite directly. - Shall there be any area showing corrosion: Clean with metallic brush or any abrasive tool till all the loose rust has been cleaned. (Till Sa 2 1/2 or equivalent)- Do not forget the recommended thickness in order to give the appropriate protection against corrosion. Galvanized: Previously apply Montoprimer Imprimación Multiadherente.
PVC: Clean dirt, oil-fat and use sand paper before applying multi adherent primer.
New Woods:
- Previously apply Selladora Sellalux l (refer to technical sheet)-Over new woods, if preventive protection over bacteria is desired, apply Montoxyl Fondo (cod. 1301) - Construction (plaster, cement and derivatives):
- These supports should be treated as standard ones, clean of saltpetre, excess of humidity or any dirt. - Eliminate any strange products or remains. - Once dry, apply primer Selladora Sellalux (refer to technical sheet) Restauracion y Mantenimineto:
Iron, wood, construction and glazed ceramics:
- Over matt painted surfaces which are still in good conditions, clean and apply directly.
- Over satin and glossy surfaces which are still in good conditions, clean, sand down slightly in order to improve adherence, and apply directly. - Over any paint which is in bad conditions or about to come off, clean it totally with mechanical or chemical means and act as with a new surface.