MONTONATURE BRILLANTE

-Stir product throughly.
-Only apply on clean surfaces, clean off any dirt by using clean water and detergents.
-Follow guidelines as shown in table below.
-Should it be applied on specific metals, different types of galvanized or difficult surfaces, we recommend priming with Ecoprimer first.
-New wood should be previously primed with Montoxyl Fondo (ref. 1301) to prevent surface from fungus and harmul bacteries.
-Do not apply product at high temperatures or overheated surfaces exposed to sunshine.
-Keep room well ventilated while product is drying.
-Do not apply when moisture contents it over 80%.

Soporte Nuevo:
Construction (plaster, cement and by-products).
-Surface should be completely dry.
-Remove off any efflorescences and neutralize alkaline surfaces.
-Remove off any foreign product or remains. Apply suitable plaster.
-Mildewed surfaces should be treated with Montolimp.
-Anchor with Fijamont or Emulsion Fijadora.
New wood:
-Surface should be free of any foreign products or remains.
-Apply on wood with less than 20% moisture content.
-Apply on wood in good condition, dry and free of grease and dust.
-Sandpaper and eliminate any remains in joints and mechanical faults.
-Old wood should be previously sandpapered and primed. Remove any dust by brushing off or using any other mechanical system.
.
-In this case, we recommend priming with Ecoprimer (ref. 1890), Selladora Sellalux (ref. 2340) or Pasta Mate Industrial (ref. 1780).
Iron and by-products:
-For surface protection prior to decoration, apply a suitable primer (See familily 9) following its corresponding data sheet guidelines.
-Prior to decoration, surface should be free of any foreign products, grease, dust and completely dry. Should it show any rust, apply our Oxifin or remove it by brushing off or any other mechanical system.
-Follow by applying suitable primer. Restauracion y Mantenimineto:
Iron and its enamelled by-products:
-Paints in good condition should be sandpaper to open pore and adherence level checked.
-Paints in bad condition should be removed by mechanical systems or chemical products proceeding then as per new surfaces.
Painted or varnished surfaces:
-If they have been varnished with Montoxyl, remove off foreign remains, or areas in bad condition, sandpaper slightly, brush any resulting dust and proceed as per new wood.
-If the have been varnished, apply a stripping product such as Quitamont Universal (ref. 3510) or use a mechanical system and proceed as per new wood. If surfaces are in good condition, sandpaper slightly, brush any resulting dust and proceed as per new wood. Allows to be painted over.
Painted construction materials: (plaster, cement and by-products):
-Remove off any foreign remains or areas in bad condition, sandpaper sligthly, brush any resulting dust and proceed as per new wood.