ESTELAR+ MATE

• Shake the product until it is perfectly homogeneous.

• Dilute the product based on the porosity and condition of the substrate in the first layer.

• Finish with one or more slightly diluted layers until total coverage of the substrate.

• Do not apply the product at temperatures below 5ºC or on surfaces exposed to strong sunlight.

• Do not wash until after 24 days.

• Outdoors, never apply with the risk of imminent rain and avoid excessively humid days. - Clean tools with water immediately after use.

• For airless spray application, use nozzles with a passage from 15 to 23 inches, pressure ≈ 150 bar.

New Substrate:

Cement and concrete mortars:

1. Wait until fully cured (min 30 days).

2. Clean any efflorescence with abrasive blasting.

3. Neutralize alkaline surfaces.

4. On polished surfaces: sand to open the pore.

5. Clean the substrate of foreign substances.

6. Fix crumbling substrates with Fixing Emulsion or Fijamont.

7. Fill defects in the substrate (see family 6). Plaster, plastered brick:

8. Wait until it is completely dry (max 20% humidity).

9. Clean the substrate of foreign substances.

10. Clean any efflorescence with abrasive blasting.

11. Adjust substrate absorptions with sealer, Fixing Emulsion, or a diluted coat of the same product. 5. On polished surfaces: sand to open the pore 6. Fix crumbling substrates with Fixing Emulsion or Fijamont.

12. Fill defects in the substrate (see family 6). Drywall:

13. Perform a general sanding of the joints and filled areas.

14. Subsequently, clean to ensure that the substrate is free of dust, grease, and other contaminants.

15. For application on boards with a tendency to generate stains, apply Montoplac Stain-Blocking Sealer. Restoration and Maintenance:

16. Completely remove old, damaged, or poorly adhered paints.

17. Matte glossy surfaces to ensure good adhesion.

18. For painted surfaces, check the solidity and anchoring of the paint, diagnose its nature to avoid possible incompatibilities, and remove dust and dirt before repainting.

19. Fill defects in the substrate with plaster (Plasmont).

20. On walls with mold, treat previously with Montolimp.