ESMALTE SECADO RAPIDO ACQUA

• Bases are tinted following the machine and Tintometric System instructions.

• The final product is applied as follows: Stir the product until perfectly homogeneous.

• Apply on clean and dry substrates, removing dirt with degreasers or detergents and clean water.

New Surface:

Iron and its derivatives:

1. To protect the surface before decoration, treat with suitable primers (family 6) following the specifications outlined in their datasheet.

2. For surface decoration, it must be free of foreign substances and/or residues, well degreased, dust-free, and dry. If signs of rust are present, rust must be removed by brushing or any other mechanical means. Oxifin is also suitable (see technical datasheet).

New Woods:

1. The surface must be free of foreign substances and/or residues.

2. Apply on woods with a moisture content below 20%.

3. Apply on healthy woods, well degreased, dust-free, and dry.

4. Sand and remove possible glue residues in joints and machining flaws.

5. If the wood shows signs of aging, it must be sanded, primed, and dust removed by brushing or any other mechanical means.

6. In this case, the most suitable primer is Sellalux Sealer.

Construction (plaster, cement, and derivatives):

1. Treat these supports in the usual way, eliminating efflorescence, excess moisture, and saltpetre.

2. Remove foreign substances and/or residues.

3. Once dry, prime with Sellalux Primer. Restoration and Maintenance:

Steel, iron, and their enamel derivatives:

1. On paints in good condition, sand to open the pores, ensuring perfect adhesion.

2. On paints in poor condition, remove them by mechanical or chemical means and proceed as with a new surface.

Varnished or painted woods:

1. If varnished with Montoxyl color: remove foreign substances, eliminate poorly adhered or damaged areas, sand lightly, remove the dust resulting from sanding, and proceed as with new woods.

2. If varnished, remove using Universal Remover or by mechanical means and proceed as with new woods.

3. If painted with synthetic enamel (Montosintetic, Marisma, Luxatin, or similar), open the pores by sanding, remove the resulting dust, and proceed as with new woods.