MONTOXYL BARNIZ ACQUA FONDO

Application notes

- Do not apply the product at high temperatures or on surfaces exposed to strong sunlight.

- Maintain good ventilation during the drying time.

- Do not apply at relative humidity levels above 80%.

- Observe the maximum time between coats to avoid adhesion problems.

- Always sand between coats and before applying the topcoat.

- Never apply coat thicknesses greater than 120 g/m2 wet per coat.

New surfaces

New Wood:

1. The substrate must be free of foreign matter and/or residue.
2. Apply to wood with a moisture content of less than 12%.
3. Apply to healthy, well-degreased, dust-free, and dry wood.
4. Sand and remove any glue residue from joints and machining defects.
5. If the wood shows signs of aging, it must be sanded first, and dust must be removed by brushing or other mechanical means.
6. To change the appearance and color of the wood, Montoxyl Lasur Acqua Colored Base Coat can be used as a direct stain on new wood before applying the first coat of Montoxyl Transparent Base Coat.
7. Sand, once dry, before applying the final finish.

Restoring and maintenance
Varnished or painted wood:
1. If varnished or lacquered with solvent-based products, remove the varnish using a universal stripper or mechanical means, down to the new wood.
2. If varnished with water-based products or stains, sanding is not necessary without completely removing the varnish and re-varnishing.
2. In any case, check the adhesion to the previous varnish, and if in doubt, remove it completely.

- Transparence

- Does not alter support tone once dry

- Low odour

- Non Yellowing

- Saves time and application cost

- Good performance

- Water-based

- Drying fast

- High filling capacity

- Very easy to sand

- Good applicability

- Good thixotropy that facilitates vertical application

- Optimises finish application