MONTOXYL BARNIZ ACQUA MATE

Application notes

- Stir the product until completely smooth.

- Do not apply the product at high temperatures or on surfaces exposed to strong sunlight.

- Maintain good ventilation during the drying time.

- Do not apply at relative humidity levels above 80%.

- Observe the maximum time between coats to avoid adhesion problems.

- Recoat with the same product within 3-24 hours without sanding.

- On Base Coat, always sand between coats and before applying the top coat.

- Never apply coat thicknesses greater than 110 g/m2 wet per coat.

New surfaces

New wood:

1. The substrate must be free of foreign matter and/or residue.

2. Apply to wood with a moisture content of less than 12%.

3. Apply to healthy, well-degreased, dust-free, and dry wood.

4. Sand and remove any glue residue from joints and machining defects.

5. If the wood shows signs of aging, it should be sanded first, and dust should be removed by brushing or other mechanical means.
6. Applying Montoxyl Clear Water Base Varnish over the sanded surface provides the best finish and optimal performance.

Restoring and maintenance

Varnished or painted wood:

1. If varnished or lacquered with solvent-based products, remove the varnish using a universal stripper or mechanical means, down to the new wood.

2. If varnished with water-based products or stains, sanding is not necessary without completely removing the varnish and re-varnishing.

3. In all cases, check the adhesion to the previous varnish, and if in doubt, remove it completely.

- Waterproof

- Transparence

- Does not alter support tone once dry

- Low odour

- Very robust and resistant

- Non Yellowing

- Good performance

- Water-based

- Drying fast

- Good applicability

- Good thixotropy that facilitates vertical application