IMPRIMACION EPOXI SUELOS

Add the water to part A and stir the product until perfectly blended.
Add the catalyst and stir again until perfectly blended.
Apply to clean dry substrates.
Pavement moisture: maximum 8% measured at a depth of 2 cmDo not apply at temperatures below 10 ºC.
Do not apply at high temperatures or to surfaces exposed to strong sunlight. The ideal temperature is between 15 and 25 ºC.
The ideal relative moisture level is between 30 and 70%.
Good air circulation and renewal is recommended.

Soporte Nuevo:
FLOORS: It is essential that the product is prepared correctly. 1. Wait until it is completely set (minimum 30 days): Remove efflorescence. 2. The floor must be clean, dry and if necessary levelled. 3. Any grease and oil must be fully removed. 4. Sandblasting or bush hammering is the best solution, although in some cases a caustic soda solution diluted to 15-20%, followed by rinsing and neutralisation with hydrochloric acid is sufficient. The ideal porosity of the floor can also be achieved through sandblasting or bush hammering.
5. On floors which are moderately porous, a hydrochloric acid based chemical treatment may be sufficient followed by thorough rinsing with water.
6. If you have any doubts, before applying a treatment consult our Technical Department, as it may not always be sufficient. On asphalted surfaces, never apply at high temperatures, remove foreign products and check that no plastifiers have migrated. Restauracion y Mantenimineto:
1. Remove old paint which is loose or in bad condition using the traditional methods of mechanical stripping (sandblasting or bush hammering) or chemical stripping (Decapante Universal).
2. Check to ensure perfect adhesion between the old, well anchored paint and the new paint and that it does not affect the adhesion of the old paint to the substrate.
3. Check the compatibility/incompatibility of the product to be applied with the old paint which is in good condition to prevent any reactions between them which could change their permanent qualities.
Follow the usual procedure indicated for new surfaces.