EMULSION FIJADORA

Stir the product until perfectly blended.
- Apply on clean and dry substrates.
- Avoid gloss by diluting according to the absorption of the base. Dilution data in the Application System are a good guide.
- First sand the surface in order to guarantee perfect penetration into the substrate.
Do not apply the product at high temperatures or on surfaces exposed to strong sunlight.
- Do not apply with relative moisture over 80%.

Soporte Nuevo:
Cement mortar, plaster and derivatives:
1. Wait until the base is completely set and dry (minimum 30 days and maximum humidity of 20%).
2. Use an abrasive jet to remove any potential efflorescence from the base and neutralise alkaline surfaces.
3. Remove any strange products and/or residues from the base.
4. Sand down highly polished surfaces to open up the mortar.
5. Fill with powder or prepared filler plasters to make the right choice, see family 6.
6. It is advisable to apply Fixative Emulsion, before and after placing the filler, especially on bases in poor condition.
7. Treat mouldy bases with Montolimp. Restauracion y Mantenimineto:
1. Completely remove any old paint that is flaking away or in poor condition.
2. Shade gloss paint to ensure good adhesion.
3. Remove foreign products by the usual procedures.
4. Given that the previous coats may have come loose, often unnoticed by the operator, it is recommended that old layers be removed using a heat gun, blasting or by other means.
5. Use plaster to fill any defects in the base (In family 6 see PREPARING BASES lines corresponding to powder plaster and prepared fillers to select the right solution).
6. Apply before and after filling.