FERRORITE ESMALTE LISO

- Apply to clean, dry substrates, removing dirt with degreasing agents or detergents and clean water. - Prepare the base, as described in the sections above, PREPARATION OF NEW SURFACES AND/OR RESTORATION AND MAINTENANCE.
Stir the product until perfectly blended.
- Apply following the dilutions indicated in APPLICATION SYSTEMS- For good protection, we recommend a product thickness of 120 microns when dry. This can be achieved with 2-3 coats.
- Do not apply the product in extreme temperatures, or to surfaces exposed to strong insolation.
- Ensure good ventilation while product is drying.
- Do not apply with relative moisture over 80%.
On old paint, where the composition or adhesion is unknown, it is advisable to carry out adhesion tests

Soporte Nuevo:
Iron and steel:
- New and rusting: -- For painting, the surface must be free of other products and residues. It must also be fully degreased and with no dry calamine. -- If it shows signs of rusting, it is not necessary to remove encrusted rust. Simply sand and remove loose particles (especially loose particles of rust and calamine). Then apply Ferrorite directly.
-- If there are areas with corrosion: Remove with a metal brush or any abrasive until all loose rust has been removed (To Sa 2 1/2 or equivalent)- Use at least the minimum total film thickness recommended for optimum anti-corrosive action: total of 120 microns when dry- Galvanised iron and steel: First apply Montoprimer Imprimación Multiadherente.
- PVC: Clean, degrease, sand and apply Imprimación MultiadherenteNew wood:
- First apply Selladora Sellalux l (see Technical Product Information Sheet)- Prior to application on new woods, prime with Montoxyl Fondo (code 1301) if you require preventive protection against fungus and bacteria.
Plaster work (plaster/ gypsum, cement and derivatives):
- Treat these mediums in the usual way, removing saltpetre, excess moisture and efflorescence.
- Remove foreign products and/or waste matter.
- When dry, prime with Selladora Sellalux (see Technical Product Information Sheet) Restauracion y Mantenimineto:
Enamelled iron, wood, plaster work and paint:
- On matt paint in good condition, clean, degrease and apply directly. - On satin and brilliant paint in good condition, clean, degrease, gently roughen (sanding superficially to improve adhesion) and apply directly.
- On paint in poor condition or poorly adhering, remove it using mechanical or chemical means and proceed as on a new base.