MONTOKRIL CUBIERTAS

- Clean the surface, removing any dirt, moss, mould, etc. and wash with clean, pure water.
- Shake the product until it is evenly mixed.
- Slightly dilute the product for the first layer, depending on the porosity and condition of the surface.
- Finish off with several coats until you have applied the recommended amount.
- It is very important that the application temperature and that of the surface is between 5ºC and 35ºC.

Soporte Nuevo:
Cement mortar: 1. Wait until it has completely set (at least 30 days).
2. Clean the base to remove any residues, loose or foreign products. 3. Remove any efflorescence using an abrasive water jet, and neutralise alkaline surfaces. Sand down highly polished surfaces to open up the pore. Fill with an elastic fibre filler.
4. Before preparing the base, make sure it is completely dry, the hygrometer humidity value should be lower than 20%. 5. Apply Fijamont to any cement mortar surfaces so that it seals it and does not come into contact with Montokril Cubiertas.
6. Anchor with Primer Impermeabilización. 7. Apply Montokril Cubiertas, using a fibreglass mesh if necessary.
Catalan tile or porous matt brick: 1. The same applies as with cement mortar, without the need to apply Fijamont.
2. In all cases, treat mouldy bases with fungicide.
Polyurethane foam and asphalt shingles:
1. Verify adhesion and proceed to treat as with Catalan tile or porous brick.
2. In all cases, treat mouldy bases with fungicide. Restauracion y Mantenimineto:
1. Eliminate all traces of old deteriorated or flaking paint.
2. Glossy surfaces should be sanded lightly to improve adhesion.
3. On painted bases, check the existing paint is in good condition and firmly adhered, establish the type of paint to avoid any incompatibility, and remove dust and dirt before repainting.
4. Fill any holes in the base using plaster.
5. For surfaces with mould, treat with appropriate fungicide first.
6. Recommended use on surfaces that have already been waterproofed: 1st coat 0.
35 l/m2. 2nd coat 0.
35 l/m2.