IMPERSIL ACQUA
applications
- Outdoors/Indoors
- Cement conglomerates
- Natural stone
- Cement mortars
- Exposed brickwork
- Concrete
- Concrete
How to apply?
- Painting brush
- Roller
- Air-less gun
- Air-mix gun
- Aerographic gun
- Low preasure turbo
Colors
- Apply uniformly all over the surface. Otherwise, damp stains may appear after it has rained in areas that have not been properly covered.
- Apply onto TOTALLY dry surfaces.
- Apply at a temperature of between 5 and 35°C.
- The number of coats required will depend on the porosity of the surface. Generally, two coats will be required, although in some extreme cases (highly porous surfaces), more may be necessary, while one coat may be enough for polished surfaces.
- Bear in mind that, since this is a water-based product, if a coat is applied over the first dry one, the polysiloxane in the first coat, which has impregnated the base, will stop it from wetting it, which may lead to stains forming on the surface.
Cement mortar:
1. Wait until completely set (minimum 30 days). There should not be any traces of damp left.
2. Use an abrasive jet to remove any potential efflorescence from the base, and neutralise alkaline surfaces.
3. Remove any strange products and/or residues from the base.
4. Use outdoor plaster to fill any defects in the base (In family 6 see PREPARING BASES lines corresponding to powder plaster and prepared fillers to select a suitable solution). Dry thoroughly until there are no remaining traces of damp.
5. Treat any mouldy structures with Montolimp fungicide and allow to dry until no damp traces remain.
Plaster, exposed brick, cellular concrete, natural and artificial stone, roof tiles, bricks, fibre cement or stucco:
1. Wait until it is totally dry and there are no traces of damp left.
2. Clean the structure to be treated of any other products and/or residues.
3. Use outdoor plaster to fill any defects in the base (In family 6 see PREPARING BASES lines corresponding to powder plaster and prepared fillers to select a suitable solution). Dry thoroughly until there are no remaining traces of damp.
4. Treat mouldy surfaces with Montolimp and allow to dry until there are no remaining traces of damp. Restauracion y Mantenimineto:
1. Apply directly onto mineral surfaces such as those listed under 'new bases'.
2. Completely remove old paint.
3. Wait until it is totally dry and there are no traces of damp left.
4. Remove any strange products and/or residues from the base.
5. Apply onto clean and dry surfaces.
6. Use outdoor plaster to fill any defects in the base (in section 6, PREPARING BASES, see the lines corresponding to powder plaster and prepared fillers to select a suitable solution). Dry thoroughly until there are no remaining traces of damp.
7. Treat mouldy surfaces with Montolimp and allow to dry until there are no remaining traces of damp.
Downloads
I´m interested in this product
I´m interested in this product
Confirm the product and your contact information to be able to inform you and advise you in a personalized way.
Readily available stock
Gestión automatizada de las ubicaciones y las existencias de los productos.
Perfect orders
Los pedidos son preparados mediante radiofrecuencia reduciendo los errores en su preparación a 0.
Warehouse management
Ubicación automática de los productos en el almacén mediantes transelevador.
Fast loading
8 loading docks for 24-ton trucks.
Our own transport
Flota propia de camiones de reparto preparados para transporte ADR.
We are always close by
Cadena de tiendas propia y suministro a puntos de venta en toda España.
liter calculator
Para pintar m2 de superficie con mano(s) de pintura necesitas:
de IMPERSIL ACQUA Transparent