BARNIZ PARQUET DECOR BRILLANTE

Stir the product until it is perfectly homogeneous.

Dilute the first coat adequately to achieve good penetration into the substrate.

For very porous or very smooth backgrounds, or very hard woods, it is recommended to increase the dilution of the first coat with our Polyurethane Thinner 1410.

Never apply coat thicknesses exceeding 100 microns per coat.

It can be applied without the need for sanding between coats, although light sanding is advisable to ensure perfect adhesion, especially on woods prone to grain raising.

Sand between coats whenever more than 12 hours have passed since the last coat was applied.

Also, to achieve a finish with an excellent touch, it is advisable to sand before the final coat.

Do not apply the product in high temperatures or on surfaces exposed to strong sunlight.

Maintain good ventilation conditions during the drying time.

Do not apply in conditions with relative humidity exceeding 80%.

Since it is a product that cures with moisture, once opened, it should be used up, as exposure to ambient moisture causes it to harden.

Before applying, check that the product is completely transparent.

On porous woods, dilute the product to allow it to penetrate into the pores and eliminate the possible formation of bubbles.

Respect the minimum time between coats to avoid disruption.

Respect the maximum time between coats to avoid adhesion problems.

New Support:

New Wood:

• The support must be free from foreign products and/or residues.
• Apply to wood with a moisture content below 12%.
• Apply to sound wood, well degreased, dust-free, and dry.
• Sand and remove possible adhesive residues at joints and machining defects.
• If the wood shows signs of aging, it should be sanded and dust removed through brushing or any other mechanical means.

Restoration and Maintenance:

Varnished or Painted Wood:

• If they have been varnished with varnishes that can be thinned with white spirit, turpentine, similar solvents, or synthetic and fatty solvents, they must be removed using a universal paint stripper or mechanical means until new wood is exposed.
• If applying over genuine polyurethane varnish (polyurethane thinner is recommended for its dilution), sand to open the pores, remove the resulting dust through brushing, and re-varnish.
• In any case, check adhesion to the previous varnish, and in case of doubt, remove it.
• If household cleaning products containing silicone have been used during maintenance, it is advisable to sand the wood until it is completely removed.